News

  • Post time: Aug-10-2018

    The main cause of fixture errors in CNC lathe operation The main cause of fixture errors in the operation of CNC lathes is that the manufacturing precision of each fixture component is not high, the installation accuracy is not high, and the wear of the fixture during use is exposed. Fixture erro...Read more »

  • Post time: Aug-10-2018

    1.1 Overtravel When the feed motion exceeds the software limit set by the software or the hardware limit determined by the limit switch, an overtravel alarm will occur, and the alarm content will be displayed on the CRT. According to the CNC system manual, the fault can be eliminated. , lift the ...Read more »

  • Post time: Aug-10-2018

    Common faults in CNC machining center servo system As we all know, the machining center servo system is a system that provides power to the machine tool. Without the servo system machining center, the workpiece cannot be processed. Therefore, the servo system is very important in the machining ce...Read more »

  • Post time: Aug-10-2018

    First, the machining of iron parts in CNC machining centers is good for hard rails or good for rails.     Iron parts are relatively common workpieces. Many customers will ask if the machining center is not used in the machining center to process the iron parts. Is the “Cnc machining center ...Read more »

  • Post time: Aug-10-2018

    1. What is the CNC vacuum chuck?      Vacuum suction cups, also known as vacuum spreaders, are one of the vacuum actuators. In general, the use of vacuum chucks to grab articles is one of the cheapest methods. Vacuum chucks are available in a variety of styles. Suction cups made of rubber can be ...Read more »